Let us try to explain in a short manner as to correctly assemble ours of wire in the spindles since on that will depend mainly the correct exit on it during that launched, being a paramount factor at the time to reach these meters of moreover by supporting the fact that winding on of the most fluid possible wire or, while not having to be filled by short (reduction of the meters to be reached) nor by length (possibility of producing those feared pelucas or nodes of spider)

In this case we will fill the spindles which tica in its range D SE9000olphin delivers; one of aluminium of great special capacity and two of teflón of low capacity for casting.

I decide to use the aluminium spindle for use with 0.18, being used by my usually, another will fill we it with one 0.16 for optimal conditions and finally the third the reservemos for one 0.21 intended for mixed zones.

We will start to place as first section that which actually will be  what is last, i.e. the adhesive rat or bridge of union; then we will introduce the wire of work (into this case 250 meters of one 0.18 of confidence) and like taste of unions between wire of not too much difference, I continue to fill the reel with 100 meters of one 0.35, by finishing the remainder of the spindle until arriving at the edge of the latter with a filling of wire from 0.50 of average quality (the use of an excessively expensive wire is not necessary for this menester, since with difficulty will see we it out of the spindle).

In all this process I advise you you placed the reel in the support of a cane and used at least the first ring for the step of the wire, in this manner and while being helped by one second nobody who holds us the various reels with a certain pressure, we will obtain a filling and with a tension óptimy in the loading of the conductor.

Once Finalizado this, it will be necessary or to lay out another spindle of the same characteristics or the use of another reel with two empty spindles of similar or higher capacity.