6. to assemble it two section by section of the cane touched by the rupture without forcing anything the union and by putting a little petroleum jelly at the piece which enters having for goal lesquel if there were a certain polyester flight one does not stick the two sections, this will help so that the cane not boot while we repair it and to the end a surprise gives us and does not return good connects the joint.

7. to mix in its proportion right so that hardens correctly (usually the proportion in packing is specified), the quantity necessary of Polyester Resin (aropol) and the catalyst (peroxide mek), This it are significant to carry out it in a quite ventilated zone it being this one component highly toxic.
To lubricate a fine layer of made up in all the zone to be repaired, if one does not have experience practises it would be advisable to carry out a certain test in, - as it is known as in equipping -, certain melt of cupboard which we have available, a certain piece of old cane or this process will have
that to make it in a continuous way to avoid bad hardening of the mixture and I stick various layers,

to start to put on the glass fibre veil, by affirming it with the same brush and by it preventing that one creates grumos or of the bubbles of air, we give it turned over to the cane so that the veil is rolled up and in each return to continue to lubricate the resin, while extending well, him we give him so many returns as we create necessary according to the gravity of the damage, I gave it 4 returns, at the end, to try to leave it by more standardizes possible since on that will depend the final aspect on work.

8. Once that it hardened and completely dried to give him a sandpapering to try to balance these irregularities which remained to us preceding step, to carry out this sandpapering we can be done of the certain useful one, right or opposite curvature in a half - canes, it is here where we must light in leaving fine, fine, fine.